To crimp a cable 50 square meters,
you need the cable, you need the tubular Crimp lug
you need a small piece of sheath heat-shrink, a knife “that does not cut” to strip,
crimping pliers and a heat air gun to “heat shrink” the
sheath. First step you have to strip the cable from
50 mm2 squares over a length of 24 mm Now that the sheath is removed
can insert the lug. We have to do Now that the sheath is removed
can insert the tubular lug. We have to do watch out that all the copper strands
fit well in the pod. Here is !
we must push the pod thoroughly. Right here we see that there remains a little copper,
so we are sure that copper is in the bottom of the pod. Then
we can go to crimping. We crimped first time outside the lug we have the writing of the number 50
which indicate the matrix crimping and crimping a second
times in the bottom of the tubular lug. Two-point crimp. there is no more to insert the piece of heat-shrinkable sheath to ensure the finish. And there you go !